|
 |
|
|
 |
|
|
 |
Surface Preparation
Use a tape measure or a ruler to determine the exact area where the quote will be placed. We recommend drawing a light horizontal guide line or use a small pieces of masking tape. Make sure the surface is clean and smooth. The quote will not adhere to stucco or brick like surfaces. Words can be cut apart and stacked in rows, put on an angle, or arranged around and on windows, doors or on most wallpaper. Taping them lightly in place first will help you plan your layout. |
|
|
 |
Prepare Quote
Some quotes will come in rolls because of the length. Unwrap the quote and let it set flat until it stops wanting to roll its self up. The quotes have a transfer tape (looks and feels like white masking tape) on one side and backing paper (white and shiny) on the other. Before peeling the back paper off, burnish (rub) the surface of transfer tape to insure the quote is adhered solidly to the transfer tape. (Letters may pull away from transfer tape during shipping) |
|
|
 |
Application
Flip up the quote and carefully peel the backing paper away from the quote, which should remain on the transfer tape. The quotes can not be repositioned, so be careful to line them up where you want them. Place the taped quote on the pre-measured surface, using the lines to position the vinyl correctly onto the surface. |
|
|
 |
Burnishing
Using the wooden burnisher that comes with your letters, carefully press any air bubbles out from underneath the words. Burnish again, apply more pressure over the entire area. |
|
|
 |
Transfer Tape Removal
Carefully peel back the transfer tape. This will leave the quote on your surface. Enjoy your new look and the inspiring words. |
|
|
{Words & Quotes}